All mold and mildew problems are caused by some amount of water and moisture. When your home is the victim of a flood it can be easy to tell the cause of your mold problems. Unfortunately, many mold and mildew problems happen so discretely it could take months before a homeowner even notices. Let’s take a look at a few tips for finding and removing the mold in your home.
Most homeowners smell mold before they actually see it. If you don’t see the infected area, it’s best to check the obvious areas first. For instance, areas under sinks usually have leaks in the plumbing that cause mildew to form. Check along plumbing fixtures and water pipes in order to see if water has started leaking. If you do see an area that has become infected with mold, don’t look directly around the area for the leak. Leaking water has a tendency to travel, so the spot that has mildew might not even be near the source of the leak. If the molded area is too infected, you might want to call Stover’s Restoration for assistance.
Often times mold has a tendency to form in the most unsuspecting places. For instance, homeowners often complain about their attics having a “moldy” smell. If you’re attic has a peculiar smell, that you suspect is mold or mildew, don’t overlook it. Attics are notorious for developing mold because of faulty roofs. A small leak in a roof can cause massive water damage. What’s worse is that these leaks develop over time and allow mold and mildew to build up. A service for Mold Removal in Wichita, KS might be need in order to get rid of massive amounts of attic mold and mildew.
If homeowners spot small areas that have formed mold, it’s important that they get rid of it immediately. Mold is bad for your health and has been known to cause respiratory issues. The problem people often have with mold is that it’s so difficult to permanently get rid of. Cleaning the area with soap and water will only fix the problem temporarily. Services for mold removal in Wichita, KS use special antibacterial chemicals to permanently kill off the mold and prevent it from coming back.
1 person likes this post.