Google+  

Wisconsin Trailer Jacks: Fitting An Electric Trailer Jack

If you own a trailer, then you are probably aware that it has a tongue jack where you can connect the trailer to an RV or to the towing automobile. It is a good idea to have your manual trailer jack replaced with an electric trailer jack, for the reason that Wisconsin trailer jacks are simpler to operate than manual trailer jacks. This article will show you how to replace the manual trailer jack with an electric one. It is recommended that you get an electric trailer jack model that is designed to haul at least 3000 pounds; however this will depend on the model and type of trailer you have.

After purchasing your electric trailer jack, the first thing you have to do is place the jack stands beneath the frame rail of your trailer. After that, gradually place the tongue of your trailer down till it rests fully on the jack stand. Next, remove the bolts which are holding the tongue jack in position and then remove the old jack by lifting it out. After removing the old jack, you can place the new jack in the position where the previous jack was. After that, secure it using the new nuts and bolts.

The next thing you have to do is connect the battery to the electric jack. To do this, you have to first remove the cover of the battery compartment, and then attach and direct the wire to link the battery and the jack. Look at the instruction manual for additional info on how to do this. Place some heat shrink tubing by the tip of the wire. Get some ring terminals and then join them at the tip of the power wire. After the wiring is complete, you should test it to see if the connections are done properly. If so, replace the cover of the battery compartment. You can purchase Wisconsin trailer jacks and other types of auto parts from dependable auto parts wholesale distributes like Pioneer Rim & Wheel Wisconsin. You can visit their website for addition information before you purchase your electric trailer jack.

Be the first to like.

Shares
Share This